Calibration with incoming DMX values

Prepare the Fixtures to full desk controll

Select the fixtures which should be calibrated and set the Mix parameter all to the max value to have full controll from the lighting desk.

*By using a map input for this, simply change this values from your lighting desk.

Start Batch Calibration

Select your fixtures and start the calibrator from the inspector.

*You can also start the batch calibration with a secondary click on the fixtures out of the object tree.

Select Fixtures to calibrate

Select the rows/fixtures which should be calibrated.

*Hold the ctrl key to select specific rows/fixtures.
Hold the shift key to select a batch of rows/fixtures.

*The batch calibration automaticly adds fixtures depending on the actual selection.
You can add fixtures to this calibration if they are missing.

Set all Fixtures to Pan Tilt mode

Start with the first calibration point

!Make sure that your real light fixtures are “pointing/focusing” to the first calibration point.
If a fixture can´t access this point, please make sure you are not selecting this fixture within the batch calibration window.

Choose from the dropdown the measurement point where the real light fixtures are “pointing/focusing” to and click on “Add or Update”

Continue calibration

Repeat this steps with all other calibration points.

*Not all fixtures needs to point on each single measurement point.
You can use the selection and use for different light fixtures different measurement points during the calibration process.

Execute the calibration

before calibration

after calibration